Home >
Knowledge Base >
FAQs >
Downloads >Support by Product
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
Search Articles
| Replacement of ACOMEL DrivesValid for S300, S700 Most of the ACOMEL drives used in high frequency applications can be replaced with S300/S700 servo amplifiers with special firmware. | English | |
| Dual UseThe term "dual use" identifies the basic usability of a technology (both a machines and software) as used for both peaceful and military purposes. | English | |
| Tuning - High Frequency Spindles S300-S700Valid for S300, S700 | English | |
| WKS or DIGIFAS to SERVOSTARValid for S300, S400, S600, S700 | English | |
| KAS Simulator won't run because port 80 is usedKAS Simulator requires the use of port 80 but sometimes other applications are using it. The application will need to be stopped before Simulator can be used. There are several ways to determine what is using the port. | English | |
| Continous Motion Task on AKDIn some applications, it is necessary to execute a continuous velocity move for an undetermined length of time, and then stop at a specified angular motor position. This is done by using modulo and setting up a motion task to repeat itself indefinitely until it is set to no longer repeat. | English | |
| Using AKD Secondary Feedback in KAS pipe network application The program calculates the pulses from the secondary FB each scan and and adds to the parameter: A1_X9EncIn. | English | |
| PDMM controlling S700 over EthercatEtherCAT control of S700 drive with a KAS master (PxMM) | English | |
| What to do if the P7000 drive locks up and won't communicate.If the P7000 stepper drive "locks up" or will not communicate with the P7000Tools software, it is possible that the firmware has been lost or corrupted. If this is the case, reloading the firmware will fix it. | English |