Search Articles

Replacement of ACOMEL DrivesValid for S300, S700 Most of the ACOMEL drives used in high frequency applications can be replaced with S300/S700 servo amplifiers with special firmware. İngilizce
Dual UseThe term "dual use" identifies the basic usability of a technology (both a machines and software) as used for both peaceful and military purposes. İngilizce
Tuning - High Frequency Spindles S300-S700Valid for S300, S700 İngilizce
WKS or DIGIFAS to SERVOSTARValid for S300, S400, S600, S700 İngilizce
KAS Simulator won't run because port 80 is usedKAS Simulator requires the use of port 80 but sometimes other applications are using it. The application will need to be stopped before Simulator can be used. There are several ways to determine what is using the port. İngilizce
Continous Motion Task on AKDIn some applications, it is necessary to execute a continuous velocity move for an undetermined length of time, and then stop at a specified angular motor position. This is done by using modulo and setting up a motion task to repeat itself indefinitely until it is set to no longer repeat. İngilizce
Using AKD Secondary Feedback in KAS pipe network application The program calculates the pulses from the secondary FB each scan and and adds to the parameter: A1_X9EncIn. İngilizce
PDMM controlling S700 over EthercatEtherCAT control of S700 drive with a KAS master (PxMM) İngilizce
What to do if the P7000 drive locks up and won't communicate.If the P7000 stepper drive "locks up" or will not communicate with the P7000Tools software, it is possible that the firmware has been lost or corrupted.  If this is the case, reloading the firmware will fix it. İngilizce