Kollmorgen Support Network

Search Articles

Kollmorgen Factory AKMH O-ring LubricantWhen we assemble the AKMH motors, we use Nye Fluorocarbon Gel 880FG lubercant. English
KAS - Firefox HTTP Requester Tool to Read/Write KAS Program VariablesFirefox offers a utility  HttpRequester English
Integrating external encoder feedback in a PxMM application This article outlines setting up a digitizing axis (secondary external encoder) or encoder master in a PxMM controller application that is using the PLCopen motion engine. The encoder input port is: AKD connector X9. Acceptable formats for the master signal are: English
S700 and S300 Series Drive Connections for the Incremental Encoder Feedback Goldline Series MotorsS700 and S300 Series Drive Connections for the Incremental Encoder Feedback Goldline Series Motors This article describes the Goldline motors' incremental encoder feedback connections and Goldline motors' power connections to the S700 and English
Setup of EtherCAT master to run an AKD in “DS402: Cyclic Synchronous Position Mode”November 4, 2016 AKD Firmware 1.15.0.1 English
AKD Series Drive Connections for Incremental Encoder Feedback Goldline Series MotorsAKD Series Drive Connections for Incremental Encoder Feedback Goldline Series Motors This article describes Goldline motors incremental encoder feedback connections, Goldline motor power connections for the AKD drive.  English
AKD & Dunkermotoren Linear MotorDrive:  AKD-P00306-NBCN-0000, FW 1.15.0.1 Motor: STA2510S, 51.2mm Pole pair pitch Feedback: SIN/COS, 51.2mm pitch (one SIN cycle / 1 motor electrical cycle) Connections: English
Dynamic Mapping For AKD Modbus TCP The following application note gives an explanation and examples of implementing Dynamic Mapping for AKD Modbus TCP. English
Setup of EtherCAT Master To Run An AKD In “DS402: Profile Torque Mode”EtherCAT master configuration for Profile Torque mode. English