Kollmorgen Support Network

Search Articles

DRIVE-CLiQDRIVE-CLiQ is an open encoder interface. Kollmorgen offers AKM Motors with singleturn or multiturn Encoders and DRIVE-CLiQ Interface. The Motor feedback can be connected via an M12 connector to the SINAMICS drive System. English
Servomotors Table of Contents General English
Creating a KVB Project within KAS IDEA KVB project can easily be created from within the KAS IDE software.  Following are the step-by-step instructions.  KVB (Kollmorgen Visualization Builder) is the software used for developing HMI screens and programs for the AKI series HMI panels.  Variables in the KAS program can English
How to Recover from the Firmware or the PLC Macro Program Locking Up the S300 Servo Drive S300 firmware recovery English
How to Recover from the Firmware or the PLC Marco Program Locking Up the S700 Servo Drive How to Recover from the Firmware or the PLC Marco Program Locking Up the S700 Servo Drive English
How to Recover from the Firmware or the PLC Marco Program Locking Up the S600 Servo Drive How to Recover from the Firmware or the PLC Marco Program Locking Up the S600 Servo Drive English
KAS 2.10: Fieldbus Editor Does Not Display All Supported Network TypesThe fieldbus editor may not display all the supported network types. The network types that are not displayed are ... English
Changing variable values over Telnet to AKD BASIC programThis application note details how to pass values via Workbench terminal, Hyper terminal, or some other method ( i.e. high level programming language, etc. ) via Telnet commands. English
AKD Profinet Drive Supported ProtocolsThe Service Port on all AKD drive models supports Modbus TCP, EXCEPT the ProfiNet model (AKD-P-NxPN).  While the AKD-P-NxPN can communicate Telnet and ProfiNet at the same time, Modbus TCP support was NOT added to this model. English