Home >
Supporto Prodotto >
FAQ >
Download >Supporto Prodotto
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
Search Articles
| Clearing an AKD-C Power Supply Fault from a PxMM Application ProgramMethod 1: Add CPS.Control Object 3000 to the PDO mappings Example: | Inglese | |
| Using Analog Torque Mode in an AKD Basic ProgramWhen using torque mode in an AKD Basic program, you must set DRV.CMDSOURCE=0 (Service) and DRV.OPMODE = 0 (Torque) in the program. | Inglese | |
| Using Maple Systems EZWare Plus to AKD or AKD BASICNote: I don’t have EzWare Plus software or the HMI and no specifics on software revisions or HMI hardware revisions or models. I have no sample project. The following is based on what worked and was learned through support. | Inglese | |
| Deliver Virtual Master Position to two or more PCMM using Pipe NetworkIf two or more PCMM networks have to follow the same position set point, it's possible to use the following strategy. The image below shows a typical configuration where all the AKD drives must follow the same position set point: Orange connection is a physical pin-to-pin cable between X9 ports… | Inglese | |
| PiCPro InstallationThe following video describes installing different versions of PicPro | Inglese | |
| Using Torque Mode in an AKD Basic ProgramWhen using torque mode in an AKD Basic program, you must set DRV.CMDSOURCE=0 (Service) in the program. | Inglese | |
| Exchanging Data Between PCMM/PDMMMany applications require a number of axis so high that it's not possible to use one PCMM only. In order to get over this limitation it's possible to use more controllers with the benefits of exchanging data between them. There are three chances available: | Inglese | |
| Switching Between Two Command Sources and Operation Modes in the AKD Using a Digital InputIn the AKD drive, a digital input can be configured for mode #22 (DINx.MODE=22) – “Switch Cmd Source/OpMode” and used to switch between two configurations of Command Source and Operation Mode. | Inglese | |
| Wiring Pin-Out For AKM with Commutating Encoder to B8000 Series DrivesThis document contains pin-out information for the AKM1x and AKM2x C connectors with commutating encoder to the B8000 series of IDC drives. | Inglese |