Search Articles

Automation of the AKD Drive with a Siemens S7-1200 and S7-1500 PLC and Modbus TCPThe following utility provides a connection between AKD servo drive (other than the Profinet drive) and Siemens SIMATIC S7-1200/S7-1500 programmable logic controllers (PLC) using Modbus TCP programmed in TIA V13. inglês
Torque mode control of an axis with KAS ControllerThe attached demo project shows how to control a servo axis with a KAS controller in Torque Mode instead fo the default Position Mode. inglês
Writing Data to the PDMM SD Card or Embedded FlashThis application note describes the process of writing data to the SD card or the embedded flash on the PDMM in .CSV (comma separated variable) format.  This is a general overview for writing data.  More read/write functions can be found in the KAS help section under File Manage inglês
EMI ChecklistThis Application Note describes the various methods and combinations of methods for grounding and shielding. Following these recommendations will help minimize or eliminate problems encounters with electrical noise in your application. inglês
Changing the Com Port Number for a USB to Serial ConverterMost laptops do not have a 9-pin serial port.  So we are forced to use USB to Serial converters or adapters for communicating with devices over RS-232.  Most older GUI software only allows the selection of the lower numbered com ports, such as COM1, COM2, COM3, and COM4. inglês
PiCPro Programming SoftwareA Single-Point Solution for Total Machine Control PiCPro® offers the most flexible toolset for motion application programming available. Motion instructions are as simple to use as ladder logic counters and timers. inglês
The Importance of Feet in Machine ApplicationsThe Importance of Feet on Machine Applications Compliance in the Wrong area can be worse than no compliance inglês
Commissioning of Unknown Hall Motors with the S300Commissioning of Unknown Hall Motors with the S300 Find out the hall counting direction  HALLDIR          MPOL inglês
User Units in the PDMM Table of Contents PLCOpen Motion Engine: Setting User Units inglês