Back to top

Using linear motor with LA11 absolute magnetic encoder system (BISS-C interface)

0 votes
+ vote
Vote up!
Good day. How can I use LA11dca13bka10da00 absolute magnetic encoder system BISS-C interface with my linear motor? 
0 Comments

1 Answer

0 votes
+ vote
Vote up!

Good day,

In general there are different topics you will have to take care for. Based on the instruction it is necessary that you align the feedback reading head with the magnetic tape, while the reading head is also mounted to the linear motor.

If this is given than you will have to take care that you are able to setup the motor with your drive. Here we have different drive systems in place, e.g. AKD, S700... you can work with.

First of all ensure that the electrical connection is done properly and the shielding is setup as well, thus you will not struggle with EMC problems.

If this is done you will have to connect to via our drive software and setup the motor, feedback device, commutation angle....

This means here is a lot more work to do where you can easily run into different problems.

If this is the first time you are going to setup a linear motor with our drives, than it is highly recommended that you will request further support from the supplier of your system.

Further information can be found in our KDN if you searching for commissioning tips for our different drives.

0 Comments
ANSWER THIS QUESTION
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.

If you do not have an account, click here to register.