Back to top

Valid for S600

There are three parameters in the S300, S600, and S700 drives that define the acceleration limits, or maximum acceleration ramp and deceleration ramp.  ACC and DEC are the acceleration and deceleration limits in the velocity loop.  They are labeled in DriveGUI software as "Acc. Ramp" and "Dec. Ramp".  In the Drive.exe software for the S600, the labels are "Setp. Ramp +" and "Setp. Ramp -".  When the drive is in velocity mode, these are the only acceleration limits that apply.  They are user defined and specific to each individual application.



s300-x9-230v.jpg 

Used with 

  • S300, voltage type 230V
  • S400
s300-x9-400v.jpg 

Used with 

Connector names of Kollmorgen servo amplifiers.

Instructions for using the Hint3.exe program to load the bootloader and firmware into the S600

See the attached zip file for the Hint3.exe file and the bootloader file.

Place the Hint3.exe file in a folder on the C: drive.  Place the bootloader file (nb72_400) and firmware file (allxxx) in that same folder.

 

Downloading the bootloader file:

1.            Connect controller SR600 (S600 drive) with serial interface COM1.

Valid for S300, S400, S600, S700

Warnings

Faults which occur, but which do not cause a switch-off of the amplifier output stage (BTB/RTO contact remains closed), are indicated in the LED display on the front panel by a coded warning number.
Possible reasons and countermeasures are described in the Online Help (Appendix Trouble Shooting)

Usable with S600

Usable with S300, S600, S700

Pages