hello
I have a question about S20330 driver error
"error reported from FPGA when sendig to EEROM"
1. Occurs when downloading parameters.
2. Occurs at Factory Default
3. Occurs when saving parameters
Sometimes when the power is turned on/off after…
HI
Checking the value by mapping the S200 Drive V_BUS value to MonitorA
I wonder what the value written to MonitorA means
Please let me know if you have a formula
Ex) 24V == 0x1055
- The count that the 0x1055 value means
thank you.
The S200 updated boards use a larger FPGA with multiple feedback and filter options. Two new parameters have been introduced to select/set these options. These parameters allow the updated boards to use a single FPGA control logic release (LogicVer =…
Hi
I have a question regarding downloading the S200 driver firmware.
New S200 Driver (Serial Number Starts R-22XX-XXXXX)
Firmware download is not possible.
Firmware information
- 936-030105-1B.isc
- 936-030106-0A.isc
- S200…
HI the Tools Position Node GUI has an oscope and we would like to see what max current our drives are using but I'm not able to connect with the RS232 phone cord. I can connect with Tools Base and SynqNet GUI but it does not have a scope…
Home >
Knowledge Base >
Community >
Downloads >