Back to top
SERVOSTAR MC drivers for WIndows 7
Good day to all,
I'm new to your community and looking for information about an obsolete controller. I am trying to get the SERVOSTAR MC controller to communicate in a Windows 7 32 bit environment. The BASICMOVES software runs fine in the XP environment but doesn't recognize the controller when I install it in the Windows 7. I've tryed as well the BASICMOVES version for Windows 7 64bit but it doesn't recognize the controller either. It will work if I set up a VirtualPC XP-mode in Windows 7, but I want to avoid that.
Do I new a 64bit Windows 7 to get this to work or does someone here have another solution, apart from upgrading all the controllers and drives. Your knowledge would be appreciated. Thanks.
Submitted by Gator Mon, 04/27/2020 - 06:55
We discontinued the Servostar MC back in 2000~2004. Nothing has been done with the MC sense. I am guessing the BasicMoves software has not been updated sense the late 90s as well. We even sold off the Servotronix division who designed and built the units. http://www.servotronix.com/
If you can get it working, that may be as good as you get. Your welcome to contact Servotronix to see if they have done any work with the software.
Submitted by [email protected] Mon, 04/27/2020 - 09:00