Back to top

Servo Star 400 master/slave upload error

0 votes
+ vote
Vote up!

I have servo star 400M attached to two slave 400A and software v5.53 ks285 and tried also with v5.53 ks284

I can read the master only, how I can read the two slaves?

0 Comments

1 Answer

0 votes
+ vote
Vote up!

Hello,

How to setup the communications with the S400 servo drives is explained in the S400 Installation Manual starting on page 84.

Link to S400 Installation Manual:

https://www.kollmorgen.com/en-us/developer-network/s400-instructions-manual/

 If you still have no success with S400 communications please contact the Kollmorgen office in Ratingen, Germany for support.

[email protected]
+49 (0) 2102 9394 0

0 Comments
ANSWER THIS QUESTION
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.

If you do not have an account, click here to register.