Back to top

S400 Drive parameter interchange

0 votes
+ vote
Vote up!

Hi, I have one S403AM-PB master module (S4 family, 3A, 230..400V, Profibus) and two  S403BA-PB an Axis modules (S4 family, 3A, 230..400V, Profibus), I wish to remove servo motor from S403AM-PB master module and connect it to one of S403BA-PB Axis module. Can I transfer all the servo parameters from S403AM-PB to S403BA-PB? Is it required software? If yes, then which software? Or can I feed the parameters by using the keys?

Kindly refer the attached hardware configuration snippet.

Thank You in advance.

Attachment 
0 Comments

1 Answer

0 votes
+ vote
Vote up!

Hi,

You can contact our office in Germany for support with the S400 product.

This the email address for Technical Support in Germany: 

[email protected]

 

 

 

 

0 Comments
ANSWER THIS QUESTION
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.

If you do not have an account, click here to register.