Back to top

Position presicion Kollmogen Workbench 1.18

0 votes
+ vote
Vote up!


I have a doubt about the position of my servomotor is an akm42e - anc2c-00, how can I set the position position if I have a margin of error of 0.105 degrees, I hope to reduce it as much as possible. I am new using kollmorgen I hope you can help me. 

 

Thank you in advance for your help

0 Comments

2 Answers

0 votes
+ vote
Vote up!

The worst case accuracy of your motor's Smart Feedback Device "SFD" is +/- 9 arc-min or +/- 0.15 degrees. The actual position repeatability accuracy is normally around 1/6 of the feedback device accuracy. My AKD demo also has a motor with a Smart feedback . When I command a position, the motor position dithers around 0.003 degrees once it reaches commanded position.

0 Comments

0 votes
+ vote
Vote up!
The worst case accuracy of your motor's Smart Feedback Device "SFD" is +/- 9 arc-min or +/- 0.15 degrees. The actual position repeatability accuracy is normally around 1/6 of the feedback device accuracy. My AKD demo also has a motor with a Smart feedback . When I command a position, the motor position dithers around 0.003 degrees once it reaches commanded position.
 
0 Comments
ANSWER THIS QUESTION
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.

If you do not have an account, click here to register.