Back to top

Picpro monitor edition v14.1 comminication error

0 votes
+ vote
Vote up!

Dear all we have a critical problem i hope we can find a solution from here.

 

We have a PCI card MMC for PC in our Siemens PC Station, The memory was deleted in MMC card. So we have changed the battery because of the battery is gone.

In this case we have download the project files (Ram.bin and Ladder.bin) and the MMC is RUN situation at now.. So but the problem is here. The sercos and IO modules is not comminicating between MMC and each other. I have attached some screen shots for you to investigate. We need quick support pls. in asap

image

 

image

image

0 Comments

1 Answer

0 votes
+ vote
Vote up!
Check the communication cable connections of the I/O Blocks, you may want to replace them.   Try swapping Block I/O 2 and 3 to see if the MMC is able to communicate with Block I/O 3 when it is moved to I/O Block 2 position .  Make sure the 24 volt logic power supply you are using with MMC and Smart Drive is outputting 24 volts and the voltage is not being pulled down.
0 Comments
ANSWER THIS QUESTION
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.

If you do not have an account, click here to register.