Kollmorgen Support Network

To better serve our Kollmorgen users with questions too complex to be addressed in this space, we made the painful decision to close this Community forum.

Please submit your question using the contact us form to reach our application engineering team.

For the immediate future, you can still access and read past posts.

Thank you for understanding and for participating in the community over the years.

Linear Motor Analog Control | 25 May 2023 | |

Linear Motor Analog Control

Hi everyone,

We are using ironcore Linear Motor ICH22-100 for our operation. The motor is working fine in service mode (actually we do not know that how good it is working if we give it complex motions, but it is working smoothly for jog and trapezoidal mode). We adjusted the slider tuning value from workbench so that it is not making any noise and works smoothly.

The problem occurs as soon as we use Analog mode, the motor starts giving a loud static noise and we disable it immediately. we are using velocity loop and we have tried doing Perfomance Servo Tuner(PST) and adjusting the slider tuning, but we still get strong noise from the motor in Analog mode.

Is there any suggestions on how to deal with this issue? We are using this AKD driver AKD - P 012 07 - NB CC - E000

Someone suggested using twisted shielded wirings for analog input to the servodriver but we are already using that.

Comments & Answers

jcoleman02 | Tue, 05/30/2023 - 13:15

Duplicate entry.

About this Question

Tamim
Taxonomy: