Back to top

ADDR Parameter (S300, S700)

ASCII - Command ADDR    
Syntax Transmit ADDR [Data]    
Syntax Receive ADDR <Data>   Available in  
Type Variable rw   MMI Yes
ASCII Format Unsigned8   CANBus Object Number 3505 (hex)
DIM -   PROFIBUS PNU 1605 (dec) IND = 1 (dec)
Range 0 .. 127   DPR 5 (dec)
Default 0    
Opmode All   Data Type Bus/DPR Unsigned8
Drive State Disabled + Reset (Coldstart)   Weighting  
Start Firmware 1.0    
Configuration Yes   Last Change of this Object 1.0
Function Group drive configuration   EEPROM Yes
Short Description Multidrop address

Description

This variable defines the station address (0 to 63) for the amplifier. This address is required by the fieldbus (CANBUS, PROFIBUS, SERCOS, etc.) and for the parameter setting of the servo amplifier in a multi-axis system for an unambiguous identification of the servo amplifier within the system. You can use the keys on the front panel of the servo panel to set the station address (refer to the Installation Manual). After changing the address, all parameters should be stored in the EEPROM (see SAVE) and the amplifier should be switched off and on again.